Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.





2. Disconnect the output shaft speed (OSS) sensor electrical connector.





3. Remove the OSS sensor.
1 Remove the OSS sensor screw.
2 Remove the OSS sensor from the transmission.

Installation





1. NOTE: Inspect the OSS sensor O-ring for damage. If damaged, install a new O-ring.

Inspect and lubricate the O-ring with petroleum jelly.
1 Install the OSS sensor into the transmission.
2 Install the OSS sensor screw.
^ Tighten to 10 Nm (89 inch lbs.).





2. Connect the OSS sensor electrical connector.