Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2007 >> E 350 V8-6.0L DSL Turbo >> Repair and Diagnosis >> Powertrain Management >> Fuel Delivery and Air Induction >> Fuel Injector Control Module >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Injector Control Module: Service and Repair



FUEL INJECTOR CONTROL MODULE

Removal and Installation

1. Retrieve the module configuration. Carry out the module configuration retrieval steps of the Programmable Module Installation (PMI) procedure.

2. Turn the ignition switch to the OFF position.

3. Remove the 3 bolts and position the degas bottle aside. To install, tighten to 10 Nm (89 lb-in).






4. NOTICE: Make sure both latches are released before removing the electrical connectors or connector damage can occur.

Disconnect the fuel injector control module (FICM) electrical connectors. Position the wiring harness aside.






5. Disconnect the bulkhead connector and position aside.
- To install, tighten to 5 Nm (44 lb-in).






6. Remove the 4 bolts and the FICM.
- To install, tighten to 13 Nm (10 lb-ft).






7. To install, reverse the removal procedure.

lf the fuel injector control module was replaced, restore the module configuration. Carry out the module configuration steps of the Programmable Module Installation (PMI) procedure.
pro multis · About Operation CHARM