Console - Floor

CONSOLE - FLOOR

Edge Floor Console:

MKX Floor Console:

Removal and Installation


All vehicles
1. Position the gear shift lever to NEUTRAL.

2. NOTE: The seats must be in the full raised position to access the bolts.

Position the seats forward and remove the 2 rear bolts.
- To install, tighten to 6 Nm (53 lb-in).

3. Remove the 2 console side panels.

4. NOTE: The seats must be in the full raised position to access the bolts.

Position the seats rearward and remove the 2 side panels and 2 center bolts.
- To install, tighten to 6 Nm (53 lb-in).

5. Remove the console finish panel.

MKX only
6. Remove the storage bin.
- Remove the 2 scrivets.
- Disconnect the power point electrical connector.

7. Remove the 2 console front side bolts.
- To install, tighten to 6 Nm (53 lb-in).

All vehicles
8. Remove the 2 console-to-instrument panel bolts.
- To install, tighten to 6 Nm (53 lb-in).

9. Disconnect the floor console electrical connector from the lower right front wiring harness.
10. Remove the floor console.
11. To install, reverse the removal procedure.