Parking Brake Control: Service and Repair
Parking Brake Control
Removal and Installation
Parking Brake - Exploded View (Part 1):
Parking Brake - Exploded View (Part 2):
1. Remove the floor console. For additional information, refer to Console.
2. Remove the parking brake control boot.
^ Pull the parking brake control boot up and over the lever.
3. Release the parking brake control.
4. Remove the front cable adjusting nut.
5. Remove the 4 parking brake control bolts.
^ To install, tighten to 24 Nm (18 ft. lbs.)
6. Disconnect the warning indicator switch electrical connector.
7. Remove the parking brake control.
^ Disconnect the front parking brake cable.
8. To install, reverse the removal procedure.
^ Adjust the parking brake cable.