Power Seat Switch: Service and Repair

MEMORY SET SWITCH

Seat Backrest - Front, 40 Percent (Part 1):

Seat Backrest - Front, 40 Percent (Part 2):

Seat Cushion - Front, 40 Percent (Part 1):

Seat Cushion - Front, 40 Percent (Part 2):

Seat Cushion - Front, 60 Percent (Part 1):

Seat Cushion - Front, 60 Percent (Part 2):

Exploded View

Removal and Installation

WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.

NOTE:
- The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver seat shown, passenger similar.

1. Depower the supplemental restraint system (SRS).
2. Detach and position aside the driver seat cushion side shield cover.
3. Release the clips and remove the memory set switch.
- Disconnect the seat control switch.

4. To install, reverse the removal procedure.
5. Repower the SRS.