Body Support - Number 2

Body Support - Number 2

Body Support - Number 2:

Removal and Installation

CAUTION: When removing upper body mounts, enough adjacent body mount support bolts or nuts must be removed to prevent damage occurring to the vehicle.

NOTE:
- Body mounts must be held with a wrench on the bottom while loosening the bolt from the top.
- Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
- No lubricants of any kind are to be used during body mount support installation.

1. Remove front seat.
2. Remove the B-pillar trim panel.
3. Position the carpet aside and remove the body insulator plug button.
4. Remove the body support bolt.
- To install, tighten to 90 Nm (66 lb-ft).

5. Remove the body support washer.
6. Remove the lower body support mount.
7. Remove enough adjacent body mount bolts to allow for the removal of the upper half of the mount without damaging the vehicle.
8. Carefully raise the vehicle body enough to remove the upper body mount.
9. Remove the upper body mount.
10. To install, reverse the removal procedure.