Rear Door Window Regulator: Service and Repair

WINDOW REGULATOR AND MOTOR - REAR DOOR







Exploded View

Removal and Installation
1. Remove the rear door speaker.
2. Remove the side impact bolster.
3. Position the door latch release handle aside.

4. CAUTION: Do not touch the adhesive surface, as re-bonding will be impaired.

Remove the watershield.

5. If manual window regulator, install the window regulator handle; if power, connect the door glass operating switch electrical connector.
6. Align the regulator clamp with the access hole.
7. Push out the pin, push out the sleeve of the 2-part spacer, and remove the window glass from the regulator.

8. CAUTION: Make sure the window glass is adequately supported at the top of the opening.

Using suitable hooks, raise and secure the window glass.

9. If manual window regulator, remove the window regulator handle; if power, disconnect the door glass operating switch electrical connector.
10. Disconnect the motor electrical connector.
11. Remove the 3 bolts and the window regulator and motor.
- To install, tighten to 7 Nm (62 lb-in).

12. To install, reverse the removal procedure.