Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2007 >> Mustang V8-4.6L VIN H >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Transmission Position Sensor/Switch >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Transmission Position Sensor/Switch: Service and Repair

Digital Transmission Range (TR) Sensor

Special Tool(s):








Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.

2. WARNING: Secure the transmission to the transmission jack with a safety chain. Failure to follow these instructions may result in personal injury.

Using a suitable transmission jack, support the transmission.
3. Remove the transmission crossmember-to-floor pan screws and lower the transmission enough to gain access to the TR sensor.





4. Disconnect the digital TR sensor connector.





5. Disconnect the transmission shift cable from the manual control lever.





6. Remove the digital TR sensor screws and remove the digital TR sensor.





Installation

1. CAUTION: The digital TR sensor must fit flush against the boss on the case to prevent damage to the sensor.

Install the digital TR sensor and loosely install the screws.





2. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

NOTE: The manual lever must be in the NEUTRAL position.

Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.
^ Tighten 8 Nm (71 inch lbs).





3. Connect the transmission shift cable to the manual control lever.





4. Connect the digital TR sensor connector.





5. Install the transmission crossmember-to-floor pan screws.
^ Tighten to 63 Nm (46 ft. lbs).





6. Verify that the shift cable is adjusted correctly.
pro multis · About Operation CHARM