Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear

Material:

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the battery ground cable. For additional information, refer to Battery.
3. Disconnect the wheel speed sensor electrical connector.

4. Remove the wheel speed sensor bolt and the wheel speed sensor.
^ To install, tighten to 27 Nm (20 ft. lbs).

5. NOTE: Plug the sensor cavity and thoroughly clean the sensor mounting surface.

NOTE: Inspect the anti-lock brake sensor O-ring for damage; lightly lubricate the O-ring with axle lubricant.

To install, reverse the removal procedure.