Key Release Button

Key Release Button

Key Release Button:

Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the ignition switch lock cylinder.
1. Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2. Push the ignition switch lock cylinder release tab with a punch while pulling out the ignition switch lock cylinder.
3. If equipped, remove the tilt release lever/ handle.
4. Remove the 3 steering column cover screws and the upper and lower steering column covers.
5. Remove the key release button bolt and the key release button and spring.
^ To install, tighten to 5 Nm (44 inch lbs.)
6. To install, reverse the removal procedure.