Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2007 >> Ranger 2WD L4-2.3L VIN D >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Fluid Pan >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fluid Pan: Service and Repair

Fluid Pan, Gasket and Filter

Material:





Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.

2. NOTE: If equipped, the transmission servo heat shield must be unclipped from the fluid pan rail and positioned aside for fluid pan removal.

If equipped, loosen the nut and position the heat shield aside.





3. Drain transmission fluid.
^ Remove all the transmission fluid pan screws except for 2 in the front. Loosen the 2 front transmission fluid pan screws. Pry the rear of the transmission fluid pan down and allow fluid to drain. After fluid is drained, remove the front 2 transmission fluid pan screws.





4. Remove the transmission fluid pan.
1. Remove the transmission fluid pan.
2. Remove and discard the transmission fluid pan gasket.





5. Remove and discard the transmission fluid filter.
1. Remove the transmission fluid filter screw.
2. Remove the transmission fluid filter.





6. Clean and inspect the transmission fluid pan and magnet. Clean all mating surfaces.





Installation

1. CAUTION: Lubricate fluid filter O-ring seals with clean automatic transmission fluid or they can be damaged.

Lube and install new O-ring seals onto the transmission fluid filter.





2. Install the transmission fluid filter.
1. Position the transmission fluid filter on the main control valve body.
2. Install the transmission fluid filter screw.
^ Tighten to 10 Nm (89 inch lbs.)





3. Position the fluid pan magnet in the transmission fluid pan.





4. Install the transmission fluid pan.
1. Position a new transmission fluid pan gasket on the transmission fluid pan.
2. Install and align the transmission fluid pan.





5. Loosely install the transmission fluid pan screws.





6. Tighten the transmission fluid pan screws in a crisscross sequence.
^ Tighten to 16 Nm (12 ft. lbs.)





7. If equipped, position the servo heat shield over the servos and clip it to the pan rail.
^ Tighten to 10 Nm (89 inch lbs.)





8. NOTE: Start with a minimum of 3.7 liters (4 quarts) clean automatic transmission fluid.

Fill transmission with clean automatic transmission fluid to the correct fluid level.
9. Apply the park brake and start the engine.
10. Move the range selector lever through all the gears.
11. Check the transmission fluid level.
pro multis · About Operation CHARM