Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> Crown Victoria V8-4.6L Flex Fuel >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wheel Speed Sensor: Service and Repair

Wheel Speed Sensor - Rear

Removal and Installation








1. WARNING: Before servicing a vehicle equipped with a fire suppression system, depower the system by following the procedure in Fire Suppression System. Failure to follow the instructions may result in serious personal injury.

Remove the rear seat cushion. For additional information, refer to Seats.
2. Disconnect the rear wheel speed sensor electrical connector.
3. Push the wheel speed sensor harness grommet through the passenger compartment floor.
4. Remove the wheel and tire.
5. Disconnect the wheel speed sensor harness clips.
6. Remove the rear wheel speed sensor bolt and the sensor.
^ To install, tighten to 7 Nm (62 inch lbs.).

7. WARNING: If the vehicle is equipped with a fire suppression system, repower the system. For important safety warnings and procedures, refer to Fire Suppression System. Failure to follow these instructions may result in serious personal injury.

To install, reverse the removal procedure. If equipped with fire suppression system, repower the system.
pro multis · About Operation CHARM