Front Bumper: Service and Repair

BUMPER - FRONT

Removal and Installation







1. Remove the valence panel in the following sequence.
1 Remove the 8 pushpin retainers.
2 Remove the 7 front bumper-to-valence panel screws.
3 Remove the A/C condenser air deflector.
4 Remove the wiring harness retainer for the block heater cord.

2. NOTE: An assistant is required to remove the front bumper.

Remove the front bumper in the following sequence.
1 Remove the 4 nuts.
2 Remove the 4 bolts and remove the bumper.
- To install, tighten to 80 Nm (59 lb-ft).

3. To install, reverse the removal procedure.