Crankshaft Position Sensor: Service and Repair

CRANKSHAFT POSITION (CKP) SENSOR







Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Turn the ignition switch to the OFF position.
3. Remove the bolt and position the ground cable aside.
- To install, tighten to 47 Nm (35 lb-ft).







4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Remove the bolt, the CKP sensor and discard the O-ring seal.
- To install, tighten to 13 Nm (10 lb-ft).

6. NOTE: Apply clean engine oil to the O-ring seal prior to installation.

To install, reverse the removal procedure.
- Install a new O-ring seal.