Stabilizer Bar: Service and Repair

Stabilizer Bar and Link

Stabilizer Bar and Link:

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure correct retention of these parts.

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove and discard the stabilizer bar link upper nuts.
^ To install, tighten to 35 Nm (26 lb-ft).
3. Remove and discard the stabilizer bar link lower nuts and remove the stabilizer bar links.
^ To install, tighten to 35 Nm (26 lb-ft).
4. Remove and discard the stabilizer bar bracket nuts and remove the stabilizer bar brackets and the stabilizer bar.
^ To install, tighten to 55 Nm (41 lb-ft).
5. Inspect the stabilizer bar bushings and install a new bushing(s), if necessary.
6. To install, reverse the removal procedure.