Transaxle Support Insulator - Lower, Front

Transaxle Support Insulator - Lower, Front





Removal
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Remove the LH splash shield.





3. Remove the 7 retainers and the LH splash shield.





4. Remove the 4 bolts and the cross brace.





5. Remove the bolt for the mount and the 2 bolts for the brace.





6. Remove the rear bolt and remove the brace.





7. Remove the 2 bolts from the mount and remove the mount.

Installation
1. Install a new mount onto the cross brace and install the bolts.
^ Tighten to 115 Nm (85 lb-ft).

2. Position the cross brace in place and install the nut.
^ Tighten to 175 Nm (129 lb-ft).





3. Install the 2 bolts for the cross brace.
^ Tighten to 90 Nm (66 lb-ft).





4. Install the through bolt for the mount.
^ Tighten to 120 Nm (89 lb-ft).





5. Install the cross brace and the 4 bolts.
^ Tighten to 115 Nm (85 lb-ft).





6. Install the LH splash shield and the 7 retainers.
^ Tighten to 10 Nm (89 lb-in).





7. Install the LH splash shield.