Seat Position Sensor: Service and Repair

SEAT POSITION SENSOR







Removal and Installation

WARNING: To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal injury or death.

NOTE:
- The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic procedure again.
- Power seat track seat position sensor shown, manual seat track position sensor similar.

1. Raise the driver seat and then position it to the rear of the track.
2. Depower the SRS.
3. Remove the seat position sensor and bracket bolt.
4. Unhook the seat position sensor and bracket from the seat track cross brace.
5. Disconnect the seat position sensor electrical connector and remove the seat position sensor and bracket.
6. To install, reverse the removal procedure.
7. Repower the SRS.