Rear
FLOOR CONSOLE - REAR
Removal and Installation
NOTE: The rear floor console bracket does not need to be removed to remove the console.
1. Open the armrest and remove the storage compartment insert.
2. Remove the 4 rear floor console bolts.
- To install, tighten to 9 Nm (80 lb-in).
3. CAUTION: To prevent damage to the 2 plastic guide pegs located on the bottom of the console, pull the console straight up when removing.
Disconnect the electrical connector and remove the rear floor console.
4. CAUTION: To prevent damage to the 2 plastic guide pegs located on the bottom of the console, install the console straight down until the pegs are correctly seated in the holes.
To install, reverse the removal procedure.