Front
Stabilizer Bar and LinkStabilizer Bar and Link:
Removal and Installation
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure may result in major service expense. New parts must be installed with the same part numbers or equivalent part, if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Remove the wheel and tire.
2. Remove and discard the 2 stabilizer bar nuts and grommets.
^ To install, tighten to 35 Nm (26 lb-ft) at curb height.
3. Remove and discard the 2 stabilizer bar studs.
4. Remove the 2 stabilizer bar links.
5. NOTE: Inspect and clean the mating surfaces and the internal threads. Make sure all mating surfaces are free of foreign material and remove any thread locking compound from the internal threads.
NOTE: Rotate the stabilizer bar and pull outward to remove.
Remove the 4 stabilizer bar bracket bolts and the stabilizer bar, and the brackets and bushings.
^ Discard the bolts.
^ To install, tighten to 55 Nm (41 lb-ft) at curb height.
6. NOTE: When installing the sway bar bushings onto the sway bar, match the groove in the bushing to the upset on the sway bar.
NOTE: Inspect the stabilizer bar bushings for wear or damage. Install new bushings as necessary.
NOTE: Tighten LH side first.
Remove the 2 stabilizer bar bushings.
7. To install, reverse the removal procedure.