Front Bumper: Service and Repair

BUMPER - FRONT







Removal and Installation
1. Remove the hood release retaining bolt.
2. Position aside the hood release assembly.
- Disconnect the hood release cable routing retainer.

3. NOTE: The front bumper cover-to-front bumper bolts must be replaced with new bolts.

Remove the 3 front bumper cover-to-front bumper bolts.

4. Remove the hood-over slam bumper bolts.
5. Remove the hood-over slam bumpers.
6. Remove the 13 air dam retaining bolts.
7. If equipped, disconnect the fog lamp electrical connectors.
8. Remove the 4 bumper mounting bracket-to-front bumper nuts.
- To install, tighten to 115 Nm (85 lb-ft).

9. Remove the front bumper.
10. To install, reverse the removal procedure.
- Transfer components as necessary.