Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> F 150 4WD V8-5.4L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Front

Wheel Speed Sensor - Front, Four Wheel Drive (4WD)

Wheel Speed Sensor - Front, Four Wheel Drive (4WD):





Removal and Installation
1. Remove the wheel and tire.

2. NOTE: The harness connector is located in the engine compartment secured to the fender apron.

Disconnect the wheel speed sensor electrical connector.
3. Disconnect the 2 wheel speed sensor harness retainers from the brake hose.
4. Remove the wheel speed sensor harness from the pushpin retainer.

5. CAUTION: Do not allow the brake caliper and anchor plate assembly to hang from the brake hose or damage to the hose can occur.

Remove the 2 brake caliper anchor plate bolts and position the brake caliper and anchor plate assembly aside.
^ Support the brake caliper anchor plate assembly using mechanic's wire.
^ To install, tighten to 112 Nm (83 lb-ft).

6. NOTE: Index-mark the brake disc and wheel hub flange before removing the brake disc. Remove the brake disc.

7. Remove the bolt and the wheel speed sensor.
^ To install, tighten to 8 Nm (71 lb-in).
8. To install, reverse the removal procedure.
^ Apply brakes several times to verify correct brake operation.
pro multis · About Operation CHARM