Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> F 450 2WD Super Duty V8-6.4L DSL Turbo >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Oil Pressure Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Oil Pressure Sensor: Service and Repair

ENGINE OIL PRESSURE (EOP) SWITCH







Removal and Installation

1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls or the vehicle may be damaged.

Turn the ignition switch to the OFF position.

2. Remove the air cleaner outlet tube.
3. Disconnect the engine oil pressure (EOP) switch electrical connector.
4. Remove the EOP switch. Remove and discard the O-ring seal.
- To install, tighten to 14 Nm (124 lb-in).

5. NOTE: Apply clean engine oil to the O-ring seal prior to installation.

To install, reverse the removal procedure.
- Install a new O-ring seal.
pro multis · About Operation CHARM