Oil Pressure Sender: Service and Repair
Engine Oil Pressure (EOP) SwitchMaterial:
Removal and Installation
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If equipped, remove the 7 screws and the underbody cover.
Vehicles equipped with manual transaxle
3. Remove the 2 bolts and position the clutch slave cylinder aside.
^ To install, tighten to 22 Nm (16 lb-ft).
All vehicles
4. Disconnect the engine oil pressure (EOP) switch electrical connector.
5. Remove the EOP switch.
^ To install, tighten to 15 Nm (11 lb-ft).
6. To install, reverse the removal procedure.
^ Apply pipe sealant with Teflon(R) to the EOP switch threads.