Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> Fusion AWD L4-2.3L >> Repair and Diagnosis >> Powertrain Management >> Emission Control Systems >> Evaporative Emissions System >> Evaporative Emission Control Canister >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Evaporative Emission Control Canister: Service and Repair

EVAPORATIVE EMISSION CANISTER


Part 1:






Part 2:






Removal and Installation

WARNING:
- Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
- Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. NOTE: Clean the evaporative emission (EVAP) canister vent solenoid electrical connector and the immediate surrounding area of any dirt or foreign material.

Disconnect the EVAP canister vent solenoid electrical connector.

3. Disconnect the fresh air tube from the dust separator.
4. Disconnect the fuel vapor tube assembly-to-EVAP canister quick connect couplings.
5. Disconnect the vapor tube-to-EVAP canister quick connect couplings.
6. Remove the 2 nuts, 2 bolts and the EVAP canister assembly.
- To install, tighten to 6 Nm (53 lb-in).

7. To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. Testing and Inspection
- Carry out the EVAP repair verification drive cycle.
pro multis · About Operation CHARM