Air Temperature Sensor ( Ambient / Intake ): Service and Repair

INTAKE AIR TEMPERATURE 2 (IAT2) SENSOR







Removal
1. Disconnect the intake air temperature 2 (IAT2) sensor electrical connector.
2. Remove the IAT2 sensor.

Installation
1. Install the IAT2 sensor. Tighten the IAT2 sensor in 2 stages:
- Stage 1: Tighten the IAT2 sensor to 15 Nm (11 lb-ft).

- NOTE: During Stage 2, do not tighten the IAT2 sensor more than one full turn and do not rotate the IAT2 sensor counter clockwise after tightening.

Stage 2: Tighten the IAT2 sensor until it is aligned as shown.







2. Connect the IAT2 sensor electrical connector.