Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2008 >> Ranger 4WD V6-3.0L >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Ignition Coil >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Coil: Service and Repair

IGNITION COIL PACK

Exploded View







Removal and Installation
1. Disconnect the ignition coil electrical connector.

2. CAUTION:
- Spark plug wires must be connected correctly. Failure to follow this instruction may result in poor engine performance.
- Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.

Disconnect the spark plug wires from the ignition coil by twisting while pulling upward.

3. Disconnect the heater hose retainer from the stud bolt.
4. Remove the 2 bolts, the stud bolt and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

5. To install, reverse the removal procedure.
- Use a small, clean tool to coat the entire interior surface of the boot with silicone brake caliper grease.
pro multis · About Operation CHARM