Power Steering Pump to Steering Gear Pressure Line

Power Steering Pump to Steering Gear Pressure Line













Removal and Installation

NOTICE: When repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the pressure line-to-steering gear banjo bolt and disconnect the pressure line from the steering gear.
- Discard the 2 seals.

- To install, tighten to 48 Nm (35 lb-ft).

3. Release the clamp and disconnect the return hose from the steering gear.

4. Release the clamp and disconnect the return hose from the return line.

5. Remove the 3 pressure line bracket-to-steering gear bolts.
- To install, tighten to 9 Nm (80 lb-in).

6. Disconnect the purge valve electrical connector.





7. Disconnect the 3 PCM electrical connectors and position the wiring harness aside.





8. Remove the pressure line-to-power steering pump banjo bolt and disconnect the pressure line from the pump.
- Discard the 2 seals.

- To install, tighten to 48 Nm (35 lb-ft).

9. To install, reverse the removal procedure.

10. Fill the power steering system.