Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2009 >> Escape 2WD V6-3.0L >> Repair and Diagnosis >> Accessories and Optional Equipment >> Cellular Phone >> Communications Control Module >> Service and Repair >> Removal and Replacement >> Universal Serial Bus (USB) Cable and Port
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Universal Serial Bus (USB) Cable and Port




Universal Serial Bus (USB) Cable and Port

Floor Console Trim Panels










Universal Serial Bus (USB) Port and Cable









Removal and Installation

NOTE: The original equipment Universal Serial Bus (USB) port and cable is part of the wiring harness. It can only be serviced by overlaying a new USB port and cable.

1. Remove the transmission selector level bezel by pulling straight up.

2. NOTE: Open the floor console storage bin door.

Remove the floor console finish panel by pulling straight up.

- Disconnect the electrical connector, if necessary.

3. Remove the center instrument panel lower panel by pulling straight back.
- Disconnect the electrical connectors.

4. Remove the USB cable and port.
- Disconnect the cable from the Accessory Protocol Interface Module (APIM).

- Cut the USB port and cable ends and secure them to prevent NVH concerns.

5. To install, reverse the removal procedure.
- Secure the new USB port and cable, as necessary, to prevent NVH concerns.

pro multis · About Operation CHARM