Throttle Body: Service and Repair

Throttle Body









Removal and Installation

1. Remove the air cleaner outlet pipe.

2. Disconnect the electronic throttle control electrical connector.

3. Release the Throttle Body (TB) coolant inlet hose clamp.
- Disconnect and plug the hose.

4. Release the TB coolant outlet hose clamp.
- Disconnect and plug the hose.

5. Remove the 4 bolts and the TB.
- Discard the TB gasket.

- To install, tighten to 10 Nm (89 lb-in).

6. NOTE: Install a new TB gasket.

To install, reverse the removal procedure.