Toe Adjustment - Rear

Toe Adjustment - Rear

1. Using alignment equipment and the manufacturer's instructions, measure the rear toe.

2. Start the engine and center the steering wheel.

3. NOTE: Use a steering wheel holding device (such as Hunter(R) 28-75-1 or equivalent).

Turn the engine OFF and using a suitable holding device, hold the steering wheel in the straight-ahead position.

4. Loosen the toe link nut approximately one full turn.





5. From the opposite side, rotate the toe link bolt to achieve the specified toe setting.

6. NOTE: Make sure that the toe settings are not disturbed while tightening the nuts.

While holding the toe link bolt, tighten the nut to 100 Nm (74 lb-ft).

7. Recheck the toe settings and adjust as necessary.