Compressor To Condenser Discharge Line

Compressor to Condenser Discharge Line - 4.0L SOHC













Removal and Installation

1. Recover the refrigerant.

2. Remove the compressor-to-condenser discharge line bracket nut and detach the bracket.
- To install, tighten to 7 Nm (62 lb-in).

3. Remove the compressor discharge fitting nut and disconnect the fitting.
- Discard the O-ring seal and gasket seal.

- To install, tighten to 15 Nm (133 lb-in).

4. Disconnect the A/C pressure transducer electrical connector.

5. Remove the condenser inlet fitting nut and disconnect the fitting.
- Discard the O-ring seal.

- To install, tighten to 8 Nm (71 lb-in).

6. Remove the compressor-to-condenser discharge line.

7. To install, reverse the removal procedure.
- Install a new gasket seal and O-ring seals.

- Lubricate the refrigerant system with the correct amount of clean PAG oil.

8. Evacuate, leak test and charge the refrigerant system.