Installation

Transfer Case





4.0L









4.6L









Installation

1. Install a new transfer case-to-transmission gasket onto the transfer case.

2. NOTE: Always install new aluminum bolts. Do not reuse the old bolts.

Position the transfer case and install 7 new aluminum transfer case-to-transmission bolts.
- Tighten to 20 Nm (177 lb-in).

3. Remove the Transmission Jack from the transfer case.





4. Connect the vent hose to the transfer case.





5. Connect the shift motor electrical connector.





6. Position the skid plate and install the 4 bolts, if equipped.
- Tighten to 24 Nm (18 lb-ft).





7. Install the front driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.

8. Install the rear driveshaft. For additional information, refer to Drive/Propeller Shafts, Bearings and Joints.

9. Fill the transfer case. For additional information, refer to Transfer Case Draining and Filling Procedures.