Seat Occupant Classification Module - Air Bag: Service and Repair

Occupant Classification System Module (OCSM)



Manual Seat











Power Seat









Removal

1. NOTE: Ignition must be OFF when disconnecting the Occupant Classification System Module (OCSM) electrical connector. Otherwise, a DTC will be set in the Restraints Control Module (RCM) memory and must be cleared before releasing the vehicle.

Turn the ignition OFF and wait at least one minute.

2. Disconnect the OCSM electrical connector.

3. Remove the 2 screws and OCSM.

4. To install, reverse the removal procedure.

5. If a new OCSM has been installed, carry out the Occupant Classification Sensor (OCS) System Reset procedure. For additional information, refer to Occupant Classification Sensor (OCS) System Reset Service and Repair in the General Procedures.