Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2010 >> Flex AWD V6-3.5L >> Repair and Diagnosis >> Body and Frame >> Seats >> Seat Track >> Service and Repair >> Seat Track - Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Seat Track - Front




Seat Track - Front

Removal and Installation

WARNING: Never probe the electrical connectors on air bag, Safety Canopy(R) or side air curtain modules. Failure to follow this instruction may result in the accidental deployment of these modules, which increases the risk of serious personal injury or death.

WARNING: Never disassemble or tamper with safety belt buckle/retractor pretensioners or adaptive load limiting retractors or probe the electrical connectors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors which increases the risk of serious personal injury or death.

1. Remove the front seat. For additional information, refer to Seat - Front Seat - Front.

2. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front, Without Fold Flat Seat Backrest - Front, Without Fold Flat or Seat Backrest - Front, With Fold Flat Seat Backrest - Front, With Fold Flat.

3. NOTE: Driver seat track shown, passenger similar.

If equipped, disconnect the cushion heater mat electrical connector at the front of the seat track and separate the wire harness retainer.





4. Release the J-clips and remove the cushion trim cover and cushion foam pad.

5. Remove the seat track cover.

1. Remove the screw.

2. Slide the seat track cover stud out.

3. Slide back and remove the seat track cover.





6. NOTE: Note driver seat wire harness routing for correct installation.

Remove the cushion wire harness. For correct passenger seat wire harness routing, refer to Seat Wire Harness Routing Seat Wire Harness Routing.

7. To install, reverse the removal procedure.
- If a new seat track has been installed on a driver seat with memory, operate the seat in all directions through the full range of travel to set soft stops and avoid a premature stopping point occurrence after the vehicle is returned to the customer.

8. Install the front seat backrest. For additional information, refer to Seat Backrest - Front, Without Fold Flat Seat Backrest - Front, Without Fold Flat or Seat Backrest - Front, With Fold Flat Seat Backrest - Front, With Fold Flat.

9. Install the front seat. For additional information, refer to Seat - Front Seat - Front.

pro multis · About Operation CHARM