Computers and Control Systems: Tools and Equipment

DIAGNOSTIC TOOLS

Below is an equipment list with corresponding part numbers:

REQUIRED SAFETY EQUIPMENT:

NOTE: The rubber insulating gloves are to be worn while working on high-voltage components or high-voltage cables. They must be inspected before use and must be worn in conjunction with the leather outer glove. Any hole in the rubber glove is a potential entry point for high voltage. To inspect the glove roll it up from the open end until the lower portion of the glove begins to balloon from the resulting pressure. If the glove leaks any air it must not be used.

- Rubber insulating gloves

NOTE: The safety face shield is to be worn while working on high-voltage components or high-voltage cables.

- Safety face shield

REQUIRED EQUIPMENT:
- Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool with functionality described under Scan Tool Setup and Functionality.
- Rotunda Smoke Machine, Fuel Evaporative Emission System Tester 218-00001 (522) or equivalent.

RECOMMENDED EQUIPMENT:
- Rotunda Vacuum/Pressure Tester 164-R0253 or equivalent. Range 0-101.3 kPa (0-30 in-Hg.) Resolution 3.4 kPa (1 in-Hg.)
- Rotunda Vacuum Tester 014-R1054 or equivalent. Range 0-101.3 kPa (0-30 in-Hg.)
- Digital Multimeter (DMM) FLU77-4 or equivalent.
- Spark Tester D81P-6666-A (303-D037) or equivalent
- Non-powered test lamp

OPTIONAL EQUIPMENT:
- Rotunda Fuel (Gasoline) pressure test kit 134-R0087 or equivalent (Use tool manufacturer's instructions.)