Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2010 >> Ranger 2WD L4-2.3L >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> Wheel Speed Sensor >> Service and Repair >> Wheel Speed Sensor - Front,
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wheel Speed Sensor - Front,




Wheel Speed Sensor - Front, Rear Wheel Drive (RWD)













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the wheel speed sensor electrical connector.

3. Remove the wheel speed sensor harness bolt and unclip the retainers.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 30 Nm (22 lb-ft).

5. NOTE: Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply a light coating of the specified grease to the mounting surface.

To install, reverse the removal procedure.

pro multis · About Operation CHARM