Control Module: Service and Repair

4X4 Control Module





Removal and Installation

1. Working in the passenger compartment, pull the carpet aside, then disconnect the 4X4 control module electrical connector.





2. Disconnect the glove compartment rod. Rotate the glove compartment downward.





3. Carefully pry the 4X4 control module and bracket assembly from the holding bracket.





4. Remove the 4X4 control module and bracket assembly from the vehicle.

5. To install, reverse the removal procedure.

6. NOTICE: Failure to properly reconfigure the Active Torque Coupling (ATC) bar code information could result in driveline damage or driveability concerns.

NOTE: The Active Torque Coupling (ATC) bar code can be found etched on the ATC wire harness connector.
Using the scan tool, program the 4X4 control module for the correct ATC bar code using the ATC Bar Code Entry service function.
- The scan tool will verify that the numbers entered are valid and display a message if the information is not correct.