Seat Position Sensor: Service and Repair

Seat Position Sensor

NOTE: RH shown, LH similar.

NOTE: Manual seat shown, power seat similar.











NOTE: The air bag warning indicator illuminates when the correct Restraints Control Module (RCM) fuse is removed and the ignition is ON.

NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.

1. Remove the seat. For additional information, refer to Seats.

2. Disconnect the seat position sensor electrical connector.

3. Remove the seat track position sensor in the following sequence.

1. Pull to release the lock tab.

2. Slide back, disengage and remove the seat track position sensor.

4. To install, reverse the removal procedure.

5. To install, reverse the removal procedure.
- If equipped with power seats, apply power and ground to the pins on the horizontal seat track motor to move the seat track to the forward most position.