Cylinder Head Assembly

Cylinder Head

Tighten the bolts in 3 stages.
Stage 1: Tighten to 40 Nm (30 lb-ft).
Stage 2: Tighten an additional 90 degrees.
Stage 3: Tighten an additional 90 degrees.






Bolt re-usability

NOTE: The cylinder head bolts must be discarded and new bolts installed. They are a tighten-to-yield design and cannot be reused.


Surface Variation -- Head-to-block, Head-to-manifolds And Surface Variation -- Warpage

















a The pin bore and crank bearing bore must be parallel and in the same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 105.5 mm on each side of rod centerline.


Camshaft Bearing Cap




Tighten the bolts in the sequence shown.
Tighten to 10 Nm (89 lb-in).





Camshaft Gear/Sprocket Specifications

Intake Manifold Specifications

Exhaust Manifold Specifications