Air Dryer: Service and Repair

Air Suspension Compressor Drier









Removal and Installation

1. Remove the air compressor. For additional information, refer to Air Suspension Compressor Service and Repair.

2. Remove the compressor drier screw.
- To install, tighten to 3 Nm (27 lb-in).

3. NOTE: Make sure that the drier O-ring does not remain inside of the compressor assembly.

Rotate the compressor drier 90 degrees counterclockwise to unlock, then remove the air compressor drier.

4. NOTE: Inspect the compressor drier O-ring for damage and install a new O-ring as necessary.

NOTE: When installing the air lines, make sure the white air line is fully inserted into the fitting for correct installation.

To install, reverse the removal procedure.