Oil Pressure Sender: Service and Repair

Engine Oil Pressure (EOP) Switch

Material(s)






Exploded View










Removal

1. If equipped, remove the engine oil cooler. REFER to Oil Cooler Service and Repair.

2. Disconnect the EOP (Engine Oil Pressure) switch electrical connector.

3. Remove the EOP (Engine Oil Pressure) switch.

Installation

1. Apply Thread Sealant with PTFE to the EOP (Engine Oil Pressure) switch threads prior to installation.

2. Install the EOP (Engine Oil Pressure) switch.

- Tighten to 14 Nm (124 lb-in) plus an additional 180 degrees.

3. If equipped, install the engine oil cooler. REFER to Oil Cooler Service and Repair.