Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> F 150 4WD V8-6.2L >> Repair and Diagnosis >> Body and Frame >> Interior Moulding / Trim >> Console >> Service and Repair >> Console - Floor
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Console - Floor




Console - Floor

Mark LT, Platinum

NOTE: Floor console with flow thru vents and selector lever shown, floor console without flow thru vents and selector lever similar.









All Other Vehicles

NOTE: Floor console with flow thru vents and selector lever shown, floor console without flow thru vents and selector lever similar.









Removal and Installation

Vehicles with selector lever in floor console

1. Apply the parking brake.

2. Place the selector lever in the 1 position.

All vehicles

3. Position the front seats forward.

4. Remove the 2 floor console rear bolts.
- To install, tighten to 10 Nm (89 lb-in).

5. Position the front seats rearward.

Consoles with flow thru vents

6. Remove the LH and RH floor console lower finish panels, in the following sequence.

1. Pull the rear section of the panels outward to release the retaining clips.

2. Pull the panels toward the rear of the vehicle.

All vehicles - except Mark LT, Platinum

7. Remove the 3 screws and storage compartment door.

Vehicles with selector lever in floor console

8. NOTICE: When prying on a component, a non-marring tool must be used or damage to the component may occur.

Remove the instrument panel-to-floor console finish panel.

- Using a non-marring tool, gently pry outward at the lower corners of the instrument panel-to-floor console finish panel to release the retaining clips.





9. Remove the floor console upper finish panel.
- Lift the floor console upper finish panel upward, at the locations indicated, to release the retaining clips.





10. Remove the selector lever trim panel.
- Lift the selector lever trim panel upward releasing the retaining clips from the floor console.

11. Remove the 2 floor console-to-instrument panel bolts.
- To install, tighten to 5 Nm (44 lb-in).

12. Remove the 2 floor console front bolts.
- To install, tighten to 10 Nm (89 lb-in).

13. Position the floor console rearward.

14. Disconnect the selector lever cable from the selector lever assembly.





15. Release the selector lever cable retaining tab and remove the selector lever cable from the selector lever assembly retainer.





Vehicles without selector lever in floor console

16. Remove the 2 floor console front bolts.
- To install, tighten to 10 Nm (89 lb-in).

All vehicles

17. Disconnect the floor console electrical connector.

18. Remove the floor console.

19. To install, reverse the removal procedure.
- Make sure to align the trim panel retaining clips to the adjacent retaining clip holes.

pro multis · About Operation CHARM