Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear, Front Wheel Drive (FWD)









Removal and Installation

1. Remove the rear seat bolster. For additional information, refer to Seating Seat Bolster - Rear.

2. Disconnect the wheel speed sensor electrical connector.

3. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting Service and Repair.

4. Using a suitable tool, disconnect the grommet from the body.

5. NOTE: It is not necessary to remove the harness routing brackets.

Disconnect the wheel speed sensor harness from the brackets.

6. Remove the wheel speed sensor wire bolt and the wheel speed sensor.
- To install, tighten to 23 Nm (17 lb-ft).

7. To install, reverse the removal procedure.