Flywheel

Flywheel

Removal

1. Remove the clutch. For additional information, refer to Clutch Removal and Replacement.

2. Remove the 8 flywheel bolts.

3. NOTICE: The flywheel is a press fit on the crankshaft pilot. Do not use screwdrivers or pry bars to remove the flywheel or damage to the flywheel or engine may occur.

Remove the flywheel.

- Install 2 of the removed flywheel bolts in the 2 holes shown on the flywheel flange.

- Tighten the 2 bolts evenly to push the flywheel off the crankshaft pilot.





Installation

1. Position the flywheel on the crankshaft pilot and start the 8 flywheel bolts.

2. Tighten the flywheel bolts evenly in the sequence shown to fully seat the flywheel on the crankshaft pilot.
- Tighten to 80 Nm (59 lb-ft).





3. Install the clutch. For additional information, refer to Clutch Removal and Replacement.

4. After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.