Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2011 >> Ranger 2WD V6-4.0L >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Ignition Coil >> Service and Repair >> Ignition Coil Pack
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Coil Pack




Ignition Coil Pack





Removal and Installation

1. Disconnect the ignition coil electrical connector.

2. NOTICE: It is important to twist the spark plug wire boots while pulling upward, to avoid possible damage to the spark plug wire.

NOTICE: Spark plug wires must be connected to the correct ignition coil terminal. For additional information, refer to the Coil Terminal-to-Cylinder Relationship illustration in the Description and Operation, Engine Ignition information. Failure to follow this instruction may result in poor engine performance. Engine Ignition

Squeeze the locking tabs and twist while pulling upward, to disconnect the 6 spark plug wires from the ignition coil.

3. Remove the 4 bolts and the ignition coil.
- To install, tighten to 6 Nm (53 lb-in).

4. NOTE: Apply silicone dielectric compound to the inside of the spark plug wire coil boots.

NOTE: Be sure to reinstall the radio ignition interference capacitor under the correct ignition coil mounting bolt.

To install, reverse the removal procedure.

pro multis · About Operation CHARM