Valve Guide Seal: Service and Repair

Valve Seals









Removal

NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

1. Remove the valve spring. For additional information, refer to Valve Springs Removal and Replacement.

2. Remove and discard the valve seal.
1. Position the Valve Stem Oil Seal Remover and Slide Hammer over the seal.

2. Pull up on the Slide Hammer and Valve Stem Oil Seal Remover and remove the seal.






Installation

1. NOTE: Lubricate the valve seal with clean engine oil prior to installing.
Using the Valve Stem Oil Seal Installer, install the valve seal.






2. Install the valve spring. For additional information, refer to Valve Springs Removal and Replacement.