Safety Belt Twisted At The Safety Belt Guide

Safety Belt Twisted at the Safety Belt Guide

General Procedure

NOTE: These procedures apply to both wire-formed and stamped D-ring designs.

1. If necessary, remove the B, C or D-pillar trim panel. REFER to B-Pillar Trim Panel , REFER to C-Pillar Trim Panel - Without Inflatable Safety Belts or REFER to C-Pillar Trim Panel - With Inflatable Safety Belts or REFER to D-Pillar Trim Panel .

2. NOTE: Typical D-ring shown, others similar.
Grasp the safety belt webbing at the D-ring and fold the twisted portion of the belt webbing over itself.





3. Feed the folded portion of the safety belt webbing through the D-ring to remove the twist from the belt webbing.