Roll Restrictor

Roll Restrictor

Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the Heated Oxygen Sensor (HO2S) electrical connector bracket nut and the HO2S (Heated Oxygen Sensor) electrical connector bracket from the roll restrictor bracket.





3. NOTE: The roll restrictor bolts are different types, make note of their location prior to removal.
Remove the roll restrictor bolts, roll restrictor bracket bolts and the roll restrictor with roll restrictor bracket.






Installation

1. NOTE: The bolts are different types, make sure the bolts are in the correct location.
Install the roll restrictor with roll restrictor bracket, roll restrictor bolts and the roll restrictor bracket bolts.

1. Tighten to 70 Nm (52 lb-ft).






2. Install the HO2S (Heated Oxygen Sensor) electrical connector bracket to the roll restrictor bracket and install the HO2S (Heated Oxygen Sensor) electrical connector bracket nut.
- Tighten to 25 Nm (18 lb-ft).