Compressor to Condenser Discharge Line

Compressor to Condenser Discharge Line - 3.5L GTDI













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Recover the refrigerant.

3. Release the 4 underbody shield retainers and remove the underbody shield (if equipped).





4. Remove the lower radiator splash shield.





5. Remove the rear A/C compressor bolt.
- To install, tighten to 25 Nm (18 lb-ft).


6. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
- To install, tighten to 15 Nm (133 lb-in).


7. Remove the condenser inlet fitting nut and disconnect the fitting.
- To install, tighten to 15 Nm (133 lb-in).


8. Disconnect the A/C pressure transducer electrical connector.

9. Remove the compressor-to-condenser discharge line.

10. To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.

- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure in Heating and Air Conditioning.


11. Evacuate, leak test and charge the refrigerant system.