Wheel Speed Sensor - Rear

Wheel Speed Sensor - Rear

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Exploded View










Removal

1. With the vehicle in NEUTRAL, position it on a hoist. REFER to Lifting Points .

2. Disconnect the wheel speed sensor electrical connector.






3. Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 4.8 Nm (42 lb-in).





Installation

1. Inspect and install a new O-ring seal as necessary.





2. NOTE: Make sure that the sensor housing is clean and free of foreign material.
To install, reverse the removal procedure.